Product ID:390 CUTTING OIL (BULK)
MSDS Date:12/15/1988
FSC:9150
NIIN:00N003918
MSDS Number: BZZJB

Emergency Phone: 617-438-7000

Info Phone: 617-438-7013

Cage: 71431

Telephone: 781-438-7000/800-535-5053

Cage: 71431

MINERAL OIL, PETROLEUM DISTILLATES, HYDROTREATED (SEV)

CAS: 64742-53-6

RTECS: PY8036001

Fraction By Weight: 75-85%

OSHA PEL 5 MG/M3 (OIL MIST)

ACGIH TLV: 5 MG/M3 (OIL MIST)

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:NO Skin:YES Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:ACUTE: MINIMAL SKIN AND EYE IRRITANT.
CHRONIC: PROLONGED OR REPEATED SKIN CONTACT MAY CAUSE SKIN
IRRITATION AND MAY DEFAT SKIN.
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:SEE HEALTH HAZARDS.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

First Aid:INHAL: REMOVE TO FRESH AIR. SUPPORT BREATHING (GIVE
OXYGEN/ARTIFICIAL RESPIRATION) . SKIN: WASH SKIN WITH SOAP AND
WATER. CONTACT MD IF IRRITATION PERSISTS. EYES: FLUSH EYES FOR AT
LEAST 15 MINU TES WITH LARGE AMOUNTS OF WATER. CONTACT MD IF
IRRITATION PERSISTS. INGEST: DO NOT INDUCE VOMITING. CONTACT MD
IMMEDIATELY.

Flash Point Method:OC
Flash Point:338F,170C
Extinguishing Media:CARBON DIOXIDE, DRY CHEMICAL, FOAM OR WATER FOG.
Fire Fighting Procedures:USE NIOSH/MSHA APPROVED SCBA AND FULL
PROTECTIVE EQUIPMENT . COOL EXPOSED CONTAINERS WITH WATER.
Unusual Fire/Explosion Hazard:THERMAL DECOMPOSITION CAN PRODUCE
CHLORIDES, SO*X AND OTHER TOXIC FUMES.

Spill Release Procedures:CONTAIN SPILL TO A SMALL AREA. PICK UP WITH
ABSORBENT MATERIAL (EG SAWDUST, CLAY, SAND, ETC) AND TRANSFER TO A
SUITABLE CONTAINER FOR DISPOSAL. KEEP OUT OF SEWERS, STREAMS AND
WATERWAYS.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:KEEP CONTAINER CLOSED WHEN NOT IN USE.
DISCARD CONTAMINATED SHOES.
Other Precautions:THIS IS PETRO BASE PROD W/A FL PT ABOVE 138C(280F).
PRINCIPAL HAZ W/THIS PROD, AS W/ANY PETRO OF THIS TYPE, IS SMOKE &
FUMES PRODUCED IF USED FOR HEAVY CUTTING OPERATIONS. CARE SHOULD BE
TAKEN TO AVOI D EXCESS INHAL OF THESE BYPRODS.

Respiratory Protection:NOT NORMALLY NEEDED. IF PEL/TLV IS EXCEEDED, USE
NIOSH/MSHA APPROVED ORGANIC VAPOR RESPIRATOR FOR MISTS.
Ventilation:NO SPECIAL REQUIREMENTS, IF PEL/TLV IS EXCEEDED, PROVIDE
ADEQUATE VENTILATION.
Protective Gloves:IMPERVIOUS GLOVES .
Eye Protection:ANSI APPRVD CHEM WORKERS GOGGLES .
Other Protective Equipment:ANSI APPROVED EYE WASH & DELUGE SHOWER .
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
NONE SPECIFIED BY MANUFACTURER.

Boiling Pt:B.P. Text:>392F,>200C
Vapor Pres:NEGLIGIBLE
Vapor Density:>1
Spec Gravity:0.9
Evaporation Rate & Reference:<1 (ETHER=1)
Appearance and Odor:NONE SPECIFIED BY MANUFACTURER.
Percent Volatiles by Volume:NEGLIG

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZERS LIKE CHLORINE AND CONCENTRATED OXYGEN.
Stability Condition to Avoid:OPEN FLAMES AND RED HOT SURFACES.
Hazardous Decomposition Products:CHLORIDES, SO*X AND OTHER TOXIC FUMES.

Waste Disposal Methods:INCINERATE ABSORBED MATERIAL. CHECK LOCAL, STATE
AND FEDERAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.